openTx icons

Example templates that may not contain settings for an entire model

Lua scripts

Download

This file for OpenTX 2.3 demonstrates some novel safety switches which if accidentally knocked will not change state. These switches are ideal for complex IC models with retracts and ignition systems where accidental activation could cause injury or damage to the model. They can also be used as throttle kills on electric fixed ....

Download

custem start screen with a custem start sound file

sound clip Created
Size
Downloads

Download

It has been exciting to explore the additional capabilities of the OpenTX system provided by the Logical Switches.  I especially find the Edge functions to be useful.  With them you can create simple procedures to do quite complex functions.  This Tutorial describes each Logical Switch and also includes a few examples of such functions which give some idea how the Edge Logical Switch can be ..

Download

Sequential Switch Templates

1. Sequential switch from single 3-positon toggle, used to cycle Up/Down to access nine flight modes.  Uses switch SA.  Can also be setup for continuous looping of the list.
2. Sequential switch uses knob S1 to simulate a 5-position rotary switch ....

Download

1-8 flightmodes selectable on pot S1. with anouncement.  

this version is an slight enhancement of version 1.0.  the first version couldn't keep in sync with audio. now by putting an delay on the switch you can select the mode you want at once and the software can keep up with your choice.               ....

Download

Thanks to JP in TX for figuring out how to make the timer count seconds from anywhere.  One glitch is at the end, once it passes zero, the beeper starts in and can't seem to be shut off.  You'll see the value of 40 set up in the  Custom Function slot, that's where you put the countdown point you chose.
Gordy

Download

Download

Temporary increase of Gyro gain when a sudden pitch change is detected

Download

Enables trainer port output for use with Phoenix RC Simulator

Model mixing is based on the following setup

Download

This is an example model demonstrating variable expo based on throttle position.

http://www.rcgroups.com/forums/showpost.php?p=25844491&postcount=1135

Download

This example model demonstrates how to reduce the gain on a channel based on the throttle position.  Channel 6 is the gain and the maximum gain is set via S1.  A curve is then used to reduce the gain based on throttle position.

Download

This example model demonstrates how to reduce the gain on a channel based on the throttle position.  Channel 6 is the gain and the maximum gain is set via S1. Curve 1 sets the amount of gain that is subtracted based on the position of S1.  Curve 2 then varies the amount from Curve 1 based on the throttle position.

Download

Makes the SH switch "sticky" and changes the rates along with channel 5 output.

http://www.rcgroups.com/forums/showpost.php?p=25895134&postcount=1279

Download

Example model showing flight mode based on stick position and smoothly moving between the trim settings of each mode.

Download

Enables trainer port output for use with PC simulators.

Download

When flying wings increase in speed the sensitivity of the elevons increases as well. This mix reduces the throw of the elevons as the throttle increases. - In effect it's gives you progressive rates.

When C^ is active the travel of the elevons inhibited inverse to the position of the throttle.  

You can change this to any switch or !switch.  You can change the level of ....